F-202-3947 Fuel Sending Unit
DCM Classics
F-202-3947 Fuel Sending Unit
DCM Classics
Product Description
We have a pre-set ready to install gas tank fuel sender . These fit the Dodge trucks from 1939-1947. series. They are a very good quality 5 hole 2 wire mounting. The ohm range is 90-0 which is what stock gauges are. We always recommend that you test your fuel gauge before you install
1. Install sender with rubber seal, with float facing to the rear of truck, and install screws. 2. Place one wire on the center post and the other wire on the ground post. 3. On some occasions, if gauge is not working, follow these next steps for rewiring
1. Connect ONLY the #2 Terminal on back of gauge to wire to tank (#1 and #2 are marked on back of gauge, below ignition terminal) 2. Connect this wire from #2 to center terminal on new unit, and connect side terminal to ground, - use frame or other good g